|
|
|
|
|
|
|
|
|
|
|
| WideBank 28 | Adit & Axxius 800 Accessories |
| Part Number | Item | Description |
| 740-0076 | Dual V.35 Card with V.54 Test Capability | Hardened Two-channel V.35 data card with V.54 loop back and BERT Test Capability. Requires Controller software release 1.0 or later. |
| 740-0077 | Single Channel POTS Card with Modem | Single port POTS card with on-board V.34 Dial-up modem for remote dial-in management access. Requires Controller software release 1.0 or later. |
| 740-0078 | Single Channel POTS Card | Hardened Single port POTS card for providing order-wire analog voice connection at a cell site. Requires Controller software release 1.0 or later. |
| 740-0098 | Quad Terminal Server Router Card with TBOS-to-SNMP Alarm Conversion | Hardened 4-port terminal server router card, supporting all Quad Terminal Server Router card functions, Raw TCP and TBOS-to-SNMP Alarm conversion for Alcatel microwave radios – Model 4000 and Proxim microwave radios– Lynx SC and HD series, 3100 series (3100,31600, 31650, 31800). Each port is strap selectable for 10/100BaseT or RS-232 asynchronous data operation. Requires Controller software release 2.0 or later. |
| 740-0087 | Low Speed Protection Card | Low Speed Protection Card for relay card slot. Provides 1:7 interface/card protection for Quad T1 cards via rear wire wrap connections. Note: Minimum controller software release required is Rev. 1.2. Requires Quad T1 card firmware release 2.0 or higher. |
| 710-0162 | Service & Controller Card Slot Blank Faceplate | Blank faceplates for empty service card and controller card slots. |
| 710-0164 | Broadband Card Slot Blank Faceplate | Blank faceplates for empty broadband card slots. |
| 710-0163 | Power Supply Card Slot Blank Faceplate | Blank faceplates for empty power supply card slots. |
| Axxius 800 / Adit 600 Service Cards | ||
| 740-0037 | FXO-8 Card | 8 channel expansion or replacement card for FXO or DPT interface applications. Note: Minimum controller software release required is Rev. 1.2.2 for Adit 600 and Rev. 1.1 for Axxius 800 (Requires Axxius 800 power supply P/N 740-0084) |
| 740-0041 | Dual ISDN BRI Card | Two-channel ISDN BRI card for 3DS0 LULT or LUNT applications. Note: Minimum controller software release required is Rev. 1.2.2 for Adit 600 and Rev. 1.1 for Axxius 800 |
| 740-0042 | Octal ISDN BRI Card | Eight-channel ISDN BRI card for 3DS0 LULT or LUNT applications. Note: Minimum controller software release required is Rev. 1.2.2 for Adit 600 and Rev. 1.1 for Axxius 800 |
| 740-0048 | Quad ISDN BRI Card | Four-channel ISDN BRI card for 3DS0 LULT or LUNT applications. Note: Minimum controller software release required is Rev. 1.2.2 for Adit 600 and Rev. 1.1 for Axxius 800 |
| 740-0066 | Single OCU-DP Card | Single port all rate OCU-DP Card for DDS Service delivery applications. Note: Minimum controller software release required is Rev. 3.2.0 for Adit 600 and Rev. 1.1 for Axxius 800 (Requires Axxius 800 Power Supply P/N 740-0084) |
| 740-0067 | Quad OCU-DP Card | Quad port all rate OCU-DP Card for DDS Service delivery applications. Note: Minimum controller software release required is Rev. 3.2.0 for Adit 600 and Rev. 1.1 for Axxius 800 (Requires Axxius 800 Power Supply P/N 740-0084) |
| 740-0075 | Quad DS1/E1 Card | Hardened Four channel T1 card for voice and data applications. Requires Controller software release 1.0 or later. |
| 740-0079 | Quad Terminal Server Router Card | Hardened 4-port terminal server router card, supporting IP/IPX routing and layer 2 bridging. Each port is strap selectable for 10/100BaseT or RS-232 asynchronous data operation. Requires Controller software release 1.0 or later. |
| 740-0091 | Quad DS1 ADPCM Card | Quad port ADPCM Card for transcoder applications, provides 32Kbps ADPCM voice compression on Port 1. Note: Minimum controller software release required is Rev. 2.0. |
| 710-0165 | Axxius 800 Accessories | |
| 710-0166 | 19-inch Rack Installation Kit | 19-inch rack mount brackets and hardware for mounting Axxius 800 Enclosure in 19-inch rack, utilizes 2 RU of vertical rack space |
| 770-0103 | 23-inch Rack Installation Kit | 23-inch rack mount brackets and hardware for mounting Axxius 800 Enclosure in 23-inch rack, utilizes 2 RU of vertical rack space |
| 770-0104 | Axxius 800 User Manual (CD-ROM) | CD ROM version of Axxius 800 usr manual. Included with each system. |
| 770-0105 | Axxius 800 User Manual (Hard Copy) | Paper version of the Axxius 800 user manual. |
| 770-0106 | Axxius Quad TSR Card User Manual | Axxius Quad TSR card user manual |
| 750-0040 | Remote Valet User Manual | Remote Valet software user manual |
| Remote Valet Software CD | Remote Valet software for TSR remote OMT applications | |
| Part Number | Item |
Description |
| 710-0167 | Axxius Intra Office Connector Kit (26 AWG) | Axxius Intra Office Connector Kit for 26 AWG wire. Includes 16 insulation displacement connectors, 16 connector caps and a tool for inserting wire into connectors for providing insulation protection for the rear wire wrap pins |
| 710-0168 | Axxius 800 Installation Accessory Kit | Axxius 800 Installation Accessory Kit: Includes (2) 10-32 nuts, (2) 6 position screw terminals, (1) ground lug connector pressure terminal, (2) 2 position plug right angle, wiremount, and (2) 10 position, plug right angle wiremount. This accessory kit shipped with every configured system for power, ground and alarm wiring connectors. |
| 710-0169 | Axxius Intra Office Connector Kit (24 AWG) | Axxius Intra Office Connector Kit for 24 AWG wire. Includes 16 insulation displacement connectors, 16 connector caps and a tool for inserting wire into connectors for providing insulation protection for the rear wire wrap pins |
| 790-0027 | Axxius DC Input Protective Shroud Kit | Axxius DC power input protective shroud kit provides two protective covers for the VDC power input connectors. These are required to meet UL Safety compliance for installing Axxius units in non-restricted access areas. |
| Universal Accessories | ||
| 005-0002 | Null Modem Adapter | 25-pin male/25-pin male |
| 005-0007 | DB-9 to DB-25 Female Adapter | DB-9 to DB-25 female adapter |
| 005-0064 | Serial Console Cable - 12 ft. | 12 ft. serial console cable with a DB-9 female and DB-9 male |
| 005-0008 | V.35 Data Cable - 10 ft. male V.35/male Winchester | 10 ft. V.35 Data Cable - male V.35 / male Winchester |
| 005-0014 | V.35 Data Cable - 10 ft. male V.35/female Winchester | 10 ft. V.35 Data Cable - male V.35 / female Winchester |
| 005-0068 | V.35 Data Cable - 25 ft. male V.35/female Winchester | 25 ft. V.35 Data Cable - male V.35 / female Winchester |
| 005-0069 | V.35 Data Cable - 50 ft. male V.35/female Winchester | 50 ft. V.35 Data Cable - male V.35 / female Winchester |
| 005-0009 | V.35 Data Cable - 25 ft. male V.35/male Winchester | 25 ft. V.35 Data Cable - male V.35 / male Winchester |
| 005-0010 | V.35 Data Cable - 50 ft. male V.35/male Winchester | 50 ft. V.35 Data Cable - male V.35 / male Winchester |
| 005-0101 | T1 Cable - 25 ft. | 25 ft. RJ48C-to-RJ48C T1 Straight Cable, RJ45 plug on each end |
| 005-0183 | T1-Cable - 2 ft. | 2' RJ48C-RJ48C T1 Cable, Straight-Through, RJ48 plug on each end |
| 005-0102 | Ethernet Crossover Cable - 2 ft. | 2 ft. RJ45-to-RJ45 Ethernet Crossover Cable, RJ 45 plug on each end |
| 005-0103 | Ethernet Straight Cable - 6 ft. | 6 ft. RJ45-to-RJ45 Ethernet Straight Cable, RJ 45 plug on each end |
| 005-0104 | RJ48C (Jack) to DB15P (Male) T1 Connector Adapter for Ericsson Applications | RJ48C-to-DB15P T1 Connector Adapter wired for Ericsson BTS (RJ48C pin 1 to DB15 pin 1, RJ48C pin 2 to DB15 pin 2, RJ48C pin 4 to DB15 pin 7, RJ48C pin 5 to DB15 pin 6) |
| 005-0185 | DB15P (Male) to RJ48C Jack Connector Adapter with jack-posts for Nortel BTS | DB15P-to-RJ48C Jack Connector Adapter with jack-posts wired for Nortel BTS CSU replacement (RJ48C pin 1 to DB15 pin 11, RJ48C pin 2 to DB15 pin 3, RJ48C pin 4 to DB15 pin 9, RJ48C pin 5 to DB15 pin 1) |
| 005-0184 | DB15S (Female) to RJ48C Jack Connector Adapter with jack-posts for Nortel BTS | DB15S-to-RJ48C Jack Connector Adapter with jack-posts wired for Nortel BTS CSU replacement (RJ48C pin 1 to DB15 pin 9, RJ48C pin 2 to DB15 pin 1, RJ48C pin 4 to DB15 pin 11, RJ48C pin 5 to DB15 pin 1) |
| 005-0106 | RJ45-to-DB9P Connector Adapter | RJ45-to-DB9P Connector Adapter - for Quad TSR Card RS-232 asynchronous data applications |
| 005-0158 | DS3 Cable - 10 ft. BNC Female-to-SMB Plug | DS3 Cable, BNC Female-to-SMB Plug, 10 Feet |
| 005-0159 | DS3 Cable - 5 ft. BNC Female-to-SMB Plug | DS3 Cable, BNC Female-to-SMB Plug, 5 Feet |
| 005-0160 | DS3 Cable - 10 ft. SMB Plug-to-SMB Plug | DS3 Cable, SMB Female-to-SMB Plug, 10 Feet |
| 005-0161 | DS3 Cable - 5 ft. SMB Plug-to-SMB Plug | DS3 Cable, SMB Female-to-SMB Plug, 5 Feet |
| 005-0162 | DS3 Cable - 5 ft. BNC Male-to-SMB Plug | DS3 Cable, BNC Male-to-SMB Plug, 5 Feet |
| 005-0164 | DS3 Cable - 10 ft. BNC Male-to-SMB Plug | DS3 Cable, BNC Male-to-SMB Plug, 10 Feet |
| 005-0186 | Grayson LMU V.35 Adapter Cable | 6' Cable Right Angle DB-25S (Female) to SCSI-26 (male) with Latches |
| 005-0187 | Grayson LMU V.35 Adapter Cable | 10' Cable Right Angle DB-25S (Female) to SCSI-26 (male) with Latches |
| 005-0188 | Grayson LMU V.35 Adapter Cable | 25' Cable Right Angle DB-25S (Female) to SCSI-26 (male) with Latches |
| 005-0189 | Grayson LMU V.35 Adapter Cable | 50' Cable Right Angle DB-25S (Female) to SCSI-26 (male) with Latches |
You've come to the right place for High quality,
Adtran Networking products!
| Products | Terminology | Search | Order | Wanted | email | Site-Map |
NationalDataMux 2005. - All products, logo's and brand names mentioned are trademarks or registered trademarks of their respective owners.